How to connect a CentOS computer to Internet using USB Wifi Adapter ?

I have an old desktop computer with CentOS 7 operating system installed without GUI. I wanted to connect to internet using a USB wifi adapter. My internet router was located in a different room and LAN cable was not available with me. So I used netgear USB wifi adapter for establishing the internet connection. This post is about troubleshooting and fixing the connectivity issue.

The model that I have used is Netgear WNA3100M Wireless-N300 USB Mini Adapter. The picture is shown below.

wifi_network_adapter

Netgear WNA3100M

I checked the network interfaces and ip address using ifconfig command. It listed an interface named wlp18s0b1. But no ip address was assigned.

I tried ifup command. But it gave me an error as follows.

ifup wlp18s0b1

/sbin/ifup: configuration for wlp18s0b1 not found.
Usage: ifup 

Then I tried listing the USB interfaces using lsusb command and it listed the network adapter usb device. This means that the device is getting detected.

The next steps that I tried are using the nmcli command.

The following command will list all the available Wifi connection profiles.

nmcli connection show

To connect to a wifi network, use the below command. You have to pass your wifi ssid and password as shown below as arguments.

nmcli dev wifi connect your-wifi-ssid password wifi-password

My desktop got connected to the internet after triggering the above command. After this, every time I start my computer, if the desktop is not automatically connected to the internet, I issue the following commands.

nmcli connection show

nmcli connection up your-wifi-connection

This solution helped me. Hope this will help someone else also :).

Disable Sleep mode in CentOS7/RHEL7 laptop on lid close

The following tip will help you to disable the powersaving or sleep mode behavior of your CentOS or RHEL laptop or desktop. If GUI is present, the following steps will help.

Applications => Utilities => Tweak Tool => Shell => Don't suspend on lid close => ON

But if GUI is not installed, then the only option is to disable this from the commandline. It is very easy, don’t worry. Who cares about the GUI in Linux. ? 🙂 (I love the black screen)

Open /etc/systemd/logind.conf, then make edit in the following configuration. By default, the value of this config will be suspend

HandleLidSwitch=ignore

man logind.conf will provide the complete details about this configuration file. Hope this tip helps.